气体增压系统使用久了之后，其里里外外都会有许多灰尘，这时候就需要对气体增压系统进行清洗，那么在清洗气体增压系统时都应该注意些什么事项呢？
Gas supercharging system used for a long time, it has a lot of dust inside and out, then you need to clean gas pressurization system, so the cleaning gas pressurization system should pay attention to what matters?
1、不能用煤油、酒精或是其它腐蚀性液体，以防液压器元件、油箱等部件受到腐蚀，影响液压器的正常使用。
1, can't use kerosene, alcohol, or other corrosive liquid, in case of hydraulic components, fuel tanks and other components from corrosion, affect the normal use of the hydraulic device.
2、清洗气体增压系统时，液压泵运转和清洗介质加热应同时进行。因为，清洗油液的温度为五十摄氏度到八十摄氏度时，系统内的橡胶渣时很容易被除掉的。
2, clean gas pressurization system, the hydraulic pump and cleaning medium heating operation should be performed at the same time. Because, clean the oil temperature is 50 degrees Celsius to eighty degrees Celsius, in the system when the rubber is easy to get rid of.
3、液压泵工作的时候进行间歇性的运转可以提高清洗效果。
3, the hydraulic pump work for intermittent operation can improve the cleaning effect.
4、我们应该在气体增压系统的清洗油路的回路上安装过滤器，这样可以过滤掉系统内大部分的杂质。
4, we should be in the gas pressurization system of cleaning oil pipe installed on the back of the filter, so that we can filter out most of the impurities in the system.
5、清洗液压泵的时间一般在四十八小时到六十小时之间，这是由系统的复杂程度和污染程度等因素决定的。
5, general cleaning of hydraulic pump time between 48 hours to 60 hours, this is by the complexity of the system and the degree of pollution and other factors.
6、清洗结束时，不要立即使液压泵停止运转，应该使其持续运转直到液压泵气温恢复正常，这样可以防止外界湿气使内部器件生锈。
At the end of June, cleaning, don't immediately make hydraulic pump stop, should make it running until hydraulic pump temperature returned to normal, moisture rust inside device to prevent the outside world.
7、清洗完气体增压系统后要及时把回路内的清洗油去除干净。
7, after cleaning the gas pressurization system inside the loop should be timely cleaning oil clean.
为了延长气体增压系统的使用寿命，以后再清洗气体增压系统时就一定要注意上面说到的这些事项。
In order to prolong the service life of gas pressurization system, cleaning gas pressurization system later when it is important to note that the above said to these matters.
